Home › Structural Rot Repair
Structural Rot Repair
Rotted studs, subfloors, and joists replaced by a licensed Certified Building Contractor.
Structural rot repair is where long-term moisture stops being a mold problem and becomes a bones-of-the-house problem. Studs, subfloors, and joists that stayed wet for months soften, sag, and crumble — and replacing them is permit-level structural work, not handyman territory. As a licensed Certified Building Contractor (CBC1262255), we replace rotted framing and subfloors, fix the moisture source that caused the rot, and rebuild to code.
Signs the structure is involved
- Floors that feel soft, spongy, or springy underfoot
- Sagging or uneven floors, especially near bathrooms and kitchens
- Dark, crumbling wood found when a wall or floor is opened
- Doors or trim pulling away as framing shifts
- A long-running leak nobody found until the damage was deep
How we repair rot
Open & assess
Damage opened up and the full extent of the rot mapped.
Support & remove
Structure supported where needed; rotted members removed.
Replace to code
New framing, subfloor, or joists installed under CBC1262255.
Fix the source
The leak or moisture problem behind the rot is fixed.
Rebuild
Walls, floors, and finishes put back together.
On the job




Frequently asked questions
Is rotted framing dangerous?
It can be. Framing and subfloors carry the weight of the house; wood that has rotted through loses that strength, which is why floors go soft and sag. Caught early, rot is usually a contained repair. Left alone, it spreads with the moisture and the repair grows with it.
Do structural repairs need a permit?
Structural work is permit-level work in Florida, and permits are pulled when the job requires them. This is exactly the kind of repair that should be done by a licensed Certified Building Contractor — ours is CBC1262255 — and built to code.
What causes mold to keep coming back?
Mold comes back when the moisture that fed it was never fixed. Cleaning the surface without stopping the leak, the condensation, or the humidity just resets the clock. That is why every job we do includes finding and fixing the moisture source and drying the structure — and why we test again at the end.
Do you rebuild what you tear out, or do we hire another contractor?
We rebuild it. Mold Removal Plus is a licensed Certified Building Contractor (CBC1262255) as well as a licensed mold assessor and remediator, so the same company that removes the mold puts the drywall, bathroom, kitchen, or framing back together. One call, one company, start to finish — we don’t just remove it, we put the room back together.